FLUKE-789 ProcessMeter

Features and Specifications

• Fluke Connect-enabled with IR3000 FC Connector
• DMM designed to meet 1000 volt IEC 1010 CAT III standards
• Precision 1000 V, 440 mA True-rms digital multimeter
• Frequency measurement to 20 kHz
• Min/Max/Average/Hold/Relative modes
• Diode Test and Continuity Beeper
• Simultaneous mA and % of scale readout
• 20 mA dc current source / loop calibrator / simulator
• Manual Step (100 %, 25 %, Coarse, Fine) plus Auto Step and Auto Ramp
• 24 V Loop power supply
• HART mode setting with loop power (adds 250 Ω resistor)
• 1200 ohm drive capability on mA source
• Enhanced backlight with two brightness settings
• 0-100% mA Span Check buttons to toggle between 4 and 20 mA
• Infrared I/O serial port compatible with FlukeView Forms Software
• Externally accessible battery for easy battery changes
• Externally accessible fuses for easy replacement

Double Your Troubleshooting Power

The Fluke 787 ProcessMeter was the first tool to combine a loop calibrator with a DMM to give process technicians double the power in one tool. Now it's even better, the range is extended with the new Fluke 789 - the ultimate loop calibration multimeter. The 789 has a display that's not only twice as large, but also twice as bright with two levels of backlighting. And with its built-in, selectable 250 ohm HART resistor, it eliminates the need to carry a separate resistor with you. Now process technicians can do a lot more while carrying a lot less.

It can measure, source, simulate 4-20 mA signals, measure resistance, measure power, provide power to the loop and provide 250-ohm resistance to the loop. The 789 includes SpanCheck; 0% and 100% buttons to toggle between 4 and 20 mA sourcing, while the display can simultaneously show mA and percentage of scale readings for faster troubleshooting. It also delivers 1200-ohm drive capability on mA source.

What's in the Box

• Fluke 789 ProcessMeter
• AC175 Alligator Clips
• Four (4) AA 1.5 V alkaline batteries (installed)
• TL71 safety-designed test lead set

Note: Fluke does not include a calibration certificate with these meters.